Pin It

Thursday, September 24, 2020

Halloween Card, Fall Card, Friendship Card, September 2020 Paper Pumpkin Card

Here's the second card I made today using the September 2020 Paper Pumpkin kit.  I could have posted it tomorrow but I don't want to make too many of my posts with Paper Pumpkin stuff because not everyone subscribes to it.

Here's how I made my card.  I took a half-sheet of Mossy Meadow card stock and folded it in half. This card opens on the right and the fold is on the left.

On top of tat is a 3-1/2" x 4-5/8" piece of Whisper White card stock.

I cut one of the Paper Pumpkin party favors to use for the center. I cut off the sides and kept the middle. That middle piece measures 2-1/2" x 3-5/8".  I cut the Old Olive piece 2-7/8" x 4". I put a small dot of tape at the area where I think the hole will be punched out. I need the tape there to hold the pieces together and prevent them from slipping.  I took my 1-1/4" circle punch and put the piece all the way into the punch.I eyed both sides to make sure they were as even as could be and I punched the circle.  Then I took the 1-3/8" circle punch and punched the party favor circle a little bit bigger. I eyed the punch and then punched out the thin ring. You don't need the ring so toss it in recycling. I taped those two pieces together.

The words are from the kit and were stamped on Whisper White card stock using Cajun Craze ink.  I punched them with the "Classic Label" punch.  

I took a scrap piece of Whisper White card stock, mine measured 2" x 2" and I centered it on the back side of the circle. I had set Dimensionals around the circle and I affixed the scrap piece to the front layers. 

I took some black Baker's Twine from the kit and wrapped it around the two layers and tied a bow in the front. I did add a glue dot to hold the bow where I needed it to be. I set the words above the bow using Dimensionals.

I added a Dimensional to the back of the little pumpkin in the kit and set it in the center of the punched circle. 

I glued a curly piece to the front of the card just above the words. 

The front panel was done so I added Dimensionals to the back and set it in place on top of the Whisper White piece. A 4" x 5-1/4" piece of Whisper White was added to the inside and the card was done.

This was a fun card to make and it's a layout I love to use with smaller images.  

Thank you SO much for taking the time to stop by today,
Wanda

1 comment:

Wavah said...

Cute for Halloween