The base of the card is a folded half-sheet of Pumpkin Pie card stock. It opens on the right and the fold is on the left. I cut a 4" x 5-1/4" piece of Basic White card stock and taped it to the inside.
Now it's time to cut the layers. The large Basic Black layer measures 3-3/4" x 5". On top of that is a piece of DSP from the "Frightfully Fun" 12" x 12" package. It measures 3-1/2" x 4-3/4". I taped the tow pieces together and then taped that to the front of the card. I centered it as much as I could by eyeing it.
The strip was cut next. It measures 4-1/4" x 1-3/4" and it was taped to the center of the card.
The smaller Basic Black layer was cut and it measured 2-3/4" x 3-3/4". On top of that is the ghost paper from the same package of DSP. It measures 2-1/2" x 3-3/4". I taped the two pieces together and then taped that to the front of the card, centering it as much as I could by eyeing it.
The words are from the "Oh My Fright" bundle and were stamped using Basic Black ink on Pumpkin Pie card stock. I used a retired die to cut them out. It was from the "Banner Sayings" bundle. The words are still available but not the die cuts that went with them. I set them in place using dimensionals.
Using the die from the "Oh My Fright" bundle I cut the ghost out from Basic White card stock. I set it in place using dimensionals.
I added a few bats from the "Bats, Ghosts and Dots" package, plus one dot over the "i" in trick and the cared was done.
This was a pretty easy card to make. It's got lots of layers, which is what I love and it used the ghost DSP that I had found difficult to work with!
Thank you SO much for taking your time to stop in and see today's Halloween card,
Wanda
1 comment:
I have some Halloween papers that I find difficult to use, too. I may have to give your layout a try. It's definitely a great way to use some of it.
Post a Comment