Pin It

Friday, November 19, 2021

Penguin Place, Stitched Snowflakes, Christmas Card, 2021 Stampin' Up! Holiday Catalog

Today's Christmas card was fun to make. The base of my card is a folded half-sheet of Just Jade card stock. On top of that is a 4" x 5-1/4" piece of Designer Series Paper (DSP) from the "Penguin Playmates" 12" x 12" package. There's SO many fun designs in this package. 

Next I cut a 3-5/8" x 3-5/8" piece of Misty Moonlight card stock. Then I cut a 3-1/2" x 3-1/2" piece of the Fresh Freesia snowflake DSP.  I also cut a Basic White piece so there was a bit more stability to the DSP. I taped the two pieces together and then used the 2-15/16" circle die and cut the center out. I taped a piece of the dotted DSP to the back of that piece and then that was taped to the front of the car about 1/4" from the top, left side and bottom. 

Then I fussy cut the penguin, polar bear and fox from the DSP. On one of the sheets there was a lonely tree that I just couldn't put in recycling so I fussy cut it too.  I set the bear in place using Dimensionals. Then I taped the little tree to the left of it.  The penguin and fox were added using Dimensionals and tape where needed.

The words are from the "Penguin Place" set and were stamped using black Memento ink. I used the "Double Oval" punch on the words.  There's a scallpy oval on that punch and I used Misty Moonlight for the layer.  I taped the two ovals together and set them in place using Dimensionals.

I die cut a snowflake from the "Stitched Snowflakes" set using Basic White card stock. I set it in place using a tiny Dimensional. I glued a silver sequin from the "Subtle Shimmer" sequins pack to give it a bit of a sparkle.

A 4" x 5-1/4" piece of Basic White card stock was added to the inside and the card was done.

Thankyou SO very much for taking your time to stop by to see today's Christmas Card,
Wanda

1 comment:

KardsbyKadie said...

So STINKIN' CUTE Wanda. TFS!