Pin It

Tuesday, September 19, 2023

Darling Details, Happiness Abounds, Give It A Whirl, Wedding Card, Stampin' Up!

Hello and welcome to my blog. Today I have an easy wedding card to share with you. Please read on to see how I made this card.

The base of the card is a folded half-sheet of Basic White card stock. It opens on the right and the fold is on the left. 

I cut a 4" x 5-1/4" piece of Basic White card stock and taped it to the front of the card base. Then I cut another piece of Basic White card stock at 3-3/4" x 5".  I textured this piece by using my scoring board. I turned the piece over and going from right to left I started scoring it at 3-1/4" and finished at 1-5/8", making 14 scored lines on the card stock. 

Next I die cut the flowers from the "Darling Details" bundle using Basic White card stock. I die cut two of the long flowers and one of the shorter bunch. 

The circle and hearts are from the "Give it a Whirl" die set and were cut using Basic White card stock. Before I cut the hearts I textured them using the "Exposed Brick" embossing folder. I tried to cover up as much of the brick as possible so I would mostly have bumpy texture. I glued the two hearts together. And the circle piece I ended up taping the circle back on using scotch tape. If I were to make another one I would see if the "Layering Circled" die set would have one that would cover most of the back of that piece so I could just glue it instead of taping it.

The words are from the "Happiness Abounds" set and were stamped on a scrap piece of Basic White card stock using Smoky Slate ink. I trimmed them to measure 3-1/4" x 1/2".

I was now ready to assemble the card. Dimensionals were used on the back of the scored piece and it was set in place on the front of the card base. 

The circle was added next. Dimensionals were used on the back of it but I didn't press it in place because I needed to slip the die cut flower pieces under it. I had used a lot of Dimensionals on the back so I knew that the flower pieces would stick and the circle would stay in place too.

The hearts were added next using more Dimensionals. And then the word were added using even more Dimensionals!

I added a few pearls and the card was done.

This was a very easy wedding card to make and I do like how it turned out.

Thank you SO very much for taking your time to stop in and see today's wedding card,

1 comment:

KardsbyKadie said...

Oh Lordy Wanda.....You OUT-DID yourself on this card.
LOVE every single thing about what you created.
Thanks for sharing!