Flora & Fern, Moonlit Flora, Lovely Arrangements, Birthday Card, Stampin' Up!

Hello and welcome to my blog. Today I have a friendship card. I found it on Pinterest. You can see the original card by clicking here. Please read on to see how it was made.

The base of my card is a folded half-sheet of Mossy Meadow card stock. It opens on the right and the fold is on the left.

I cut a 4" x 5-1/4" piece of Golden Glow card stock for the largest layer.  On top of that is a 3-3/4" x 5" piece of Designer Series Paper from the "Moonlit Flora" 12" x 12" package. Before taping it to the Golden Glow card stock layer, I die cut the little "greenery" clusters from the "Fern & Flora" bundle. I cut two of them from the center of that piece. Once the DSP was taped to the Golden Glow piece, I taped that to the front of the card base.

I cut another piece of DSP from the same package that measures 5-1/4" x 1-1/2". I cut a 1-3/4" x 5-1/2" piece of Mossy Meadow for the layer. I taped the two pieces together. Dimensionals were added to the back and it was set in place on the left side of the card about 1/2" from the fold.

I cut a larger fern piece using Mossy Meadow and a curled fern piece using Old Olive. These dies are in the "Fern & Flora" bundle.  

The "hello" is from the "Lovely Arrangements" bundle and was stamped on a scrap piece of Basic White card stock using Basic Black ink. I had masked off the "friend" from the stamp. The "hello" was punched out using the "Three Banner" punch.  I used Old Olive ink and a dauber and added it to the edges of the piece.  I set it aside.

I taped the end of the large fern and set it in place on the front of the card. Then I added the Golden Glow piece on top of the fern with a little tape. The curled fern was added with a little bit of tape on the end.

The word piece came next. I added a Dimensional on the right side and glue on the other. I set it in place on top of the Golden Glow "greenery" piece. A little glue was added to the end of the other Golden Glow "greenery" piece and it was slipped under the word piece. I didn't have any matching ribbon so that is why I added another Golden Glow piece.  It seemed to have done the trick.

I had two retired "Patterned Dots" to the bottom left of the card and the card was done.

This was a fun card to make. It's too bad that I didn't get more of the moth on the right but what's there is enough to see it.  

Thank you SO very much for taking your time to stop in and see today's birthday card,
Wanda