Pin It

Tuesday, November 20, 2018

Itty Bitty Greetings, Santa's Workshop, Christmas Card

I love the "Santa's Workshop" Specialty Designer Series Paper.  The pom pom and brim of the hat are fuzzy.  Sometimes I will add some Wink of Stella to the fuzzy parts to give it a glittery look.

The base of my card is a folded half-sheet of Poppy Parade.  I cut a 4" x 5-1/4" piece of Whisper White card stock and taped it to the front of the card.

I cut two pieces of the white polka dot SDSP. They measure 3-7/8" x 1-3/4".  I taped them to the Whisper White piece. One on the top and one on the bottom, leaving a 1/8" border. 

I die cut a stitched circle using Whisper White card stock.

I die cut a Poppy Parade scalloped circle that was just a bit larger than the stitched circle.  I taped those two layers together. I set them in place on the card using Dimensionals.

I die cut the Santa from the "Santa's Workshop" SDSP.  I set him in place on the circles using Dimensionals.

The words are from the "Itty Bitty Greetings" set. I used Poppy Parade ink to stamp them. I punched them out using the "Classic Labels" punch.  I set them in place using Dimensionals.  

I added a 4" x 5-1/4" piece of Whisper White to the inside of the card and it was done.

I thought this was a pretty quick card to make. Not to mention SUPER easy!!

Thank you SO much for stopping by today,
Wanda

No comments: