Friday, November 01, 2019

Snowman Season, Christmas Card, 2019 Stampin' Up! Holiday Catalog

I found this fun card on Split Coast Stampers.  I though it was a fun looking card and you get to use the fun felt pieces.  

The base of the card is a folded half-sheet of Real Red card stock  On top of that are two pieces of the Designer Series Paper (DSP) from the "Let it Snow" 12" x 12" paper pack.  The top piece was cut 3" and the bottom was cut 2-1/4".  I over lapped them a little because I wanted to make sure that no red would show between the two pieces.  

I wrapped the piece of Real Red "Curly Ribbon" around the front of the card, along the seam and I taped the ends on the back with scotch tape.  

I die cut the snowman from a piece of DSP from the same "Let it Snow" paper pack.  There's some sheets in there with parts that fit in the matching paper punch.  I die cut a circle using the second largest "Stitched Circle" dies.  And I die cut a Real Red scalloped circle for the layer behind it.  I set the circles on top of the card front so I could see where to stamp the words.  The words are from the "Snowman Season" set and I stamped them using black Memento ink.

Next I taped the snowman to the circle.  I used the arms, hat and scarf from the "Let it Snow" embellishment kit.  Cute, aren't they?  There's also noses in there, coal buttons and felt snowballs.

I glued the hat and scarf in place.  The arms were sticky enamel pieces so they didn't need any tape.

I set the circle in place using Dimensionals. Be sure not to put any Dimensionals where that ribbon crosses the back of that circle.  And there you have it. An adorable and fun Christmas card,

Thank you SO much for visiting today,
Wanda

No comments:

Post a Comment