Pin It

Friday, May 18, 2012

Smarties Graduation Cap Party Favor Weekend Project


I cut a strip of black card stock 3/8” wide by 3-1/4” long.  I wrapped it around the Smarties package and poked a hole in the top one that went through the other end of the strip behind it but not all the way through.  I didn’t want it to poke a hole in the candy wrapper.  Then I punched out a 1-1/4” square and poked a hole in the center of it.  I took a brad and poked it through the square and then the two strip ends.  I folded over the brad ends and then slipped the band over the candy.   And the final touch is to tie a piece of Baker’s Twine around the brad to make it look like a tassel.  And that’s it.  These are SO simple to make and fun for that graduation party.  And it’s not chocolate so you can set them outside and not have to worry about them melting.

This was not a bit project I had brewing but it was sitting on paper for a few weeks now waiting for me to find the time to put it all together.  Lucky you, today was that day!!

Thank you SO much for visiting today,
Wanda

1 comment:

Unknown said...

These are so cute going to keep them in mind for Donna;)